What faults will be encountered in the paint production line? Below, the paint production line manufacturer will introduce its solution to you.
The initial tension is too small. The place where the production line leaves the drum is not tight enough, resulting in a decline in the production line. This situation usually occurs at startup. The solution is to adjust the tension device and increase the initial tension.
Insufficient friction between the transmission drum and the assembly line production leads to sliding. Most people don't like the reason because the paint production line has water or the environment is humid. The solution is to add some rosin powder to the drum. However, it should be noted not to add it by hand, but to blow it in with a blowing device to avoid personal accidents.
The tail drum bearing is damaged and does not rotate, or the upper and lower roller bearings are damaged and do not rotate too much. The reason for the damage is caused by too much tail floating and sinking, and the damaged or inflexible parts are not repaired and replaced in a timely manner, which increases resistance and leads to sliding.
If the starting speed is too fast, it will cause slipping. At this point, you can start slowly. If a squirrel cage motor is used, it can be restarted after jogging twice and effectively overcome slipping.
The load on the paint production line is too high, and if it exceeds the capacity of the motor, it will decline. The advantage of this decline is that the protection effect is not affected by the motor, otherwise the motor will burn out over time. But for the operation, it was a slip accident. To overcome the phenomenon of landslides in assembly lines and production, the first step is to identify the cause of the landslide and then take effective measures.
The above is a summary of knowledge about coating production lines for you. We hope it will be helpful to you. If you have any questions, please feel free to contact us. Follow our official website to learn more about coating production lines.
